Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Center Console Finish Panel of the Subaru Ascent Mk1

Model: Subaru Ascent MK 1 - Years 2018-2026
Part: Dashboard

This guide shows how to disassemble the center console of the Subaru Ascent Mk1. The first step is to remove the storage tray under the center column; it is recommended to use a plastic trim tool for this operation. At this point, simply pull the center panel to disconnect the retaining clips in the compartment; do not pull too hard as you could break the retaining pins located under the armrest. Using the plastic trim tool, lift the back of the panel and remove the piece; disconnect the handbrake button control cable. At this point, you will have access to the center console.

Updated on 16 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing the Front Door Panel on a Subaru Ascent
Removing the Front Door Panel on a Subaru Ascent
Subaru Ascent (2018-2026 / MK 1) This guide provides instructions on how to remove and replace the front door panel on a Subaru Ascent in simple steps. First, open the front door and…
How to Change the Cabin Air Filter on a Subaru Ascent
How to Change the Cabin Air Filter on a Subaru Ascent
Subaru Ascent (2018-2026 / MK 1) Replacing the cabin air filter on a Subaru Ascent is a simple task you can do yourself, thanks to our video tutorial that will guide you through the …
How to Reset the Oil Service Light in a Subaru Ascent?
How to Reset the Oil Service Light in a Subaru Ascent?
Subaru Ascent (2018-2026 / MK 1) In this tutorial, you will see how to reset the oil service light in a Subaru Ascent, a very simple operation to perform only after completing all re…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos