Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to replace the front brake pads of the Suzuki V-Strom 1000, you need to loosen the screws that secure the brake caliper to the corresponding disc: once the caliper is detached, you can proceed by removing the pin that locks the pads inside so that you can completely remove the old pads. After they have been removed, you can proceed by inserting the new ones inside the caliper, locking them with the appropriate pin: finally, you will need to reposition the caliper on the disc and verify that everything is working properly.

Posted on 8 September 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Brake Pads on a Suzuki V-Strom 1000
How to Replace the Rear Brake Pads on a Suzuki V-Strom 1000
V Strom 1000 .. To replace the rear brake pads on a Suzuki V-Strom 1000, loosen the screws that secure the corresponding brake caliper so that it can be removed from.. …
How do you replace the brake pads on the Suzuki V-Strom 1050?
How do you replace the brake pads on the Suzuki V-Strom 1050?
V Strom 1000 To replace the brake pads on the Suzuki V-Strom 1050, the same procedure must be carried out for both the front and rear wheels: you will need to loo…
How to Replace the Rear Shock Absorber on a Suzuki V-Strom 1000?
How to Replace the Rear Shock Absorber on a Suzuki V-Strom 1000?
V Strom 1000 .. To replace the rear shock absorber on a Suzuki V-Strom 1000, loosen the bolts securing it to its housing, which is located in the central part of the.. …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos