Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Coolant on a Suzuki Jimny

Model: Suzuki Jimny Jb23, Jb33, Jb43, Jb53 - Years 1998-2018
Part: Radiator

First, look under the vehicle and locate the tap to open for draining the coolant: it is clearly shown in the video. Collect the fluid in a container and dispose of it properly. Open the top cap to allow air into the system, significantly speeding up the coolant drainage process. Close the lower tap and refill the same amount of fluid drained from the upper fill hole. You can repeat the procedure a couple of times to better clean the system. As you can see, this is not a trivial operation, but you can carry it out independently.

Updated on 12 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the coolant in a Suzuki Jimny
How to replace the coolant in a Suzuki Jimny
Suzuki Jimny (1998-2018 / Jb23, Jb33, Jb43, Jb53) This video guide shows how to replace the coolant in a first-generation Suzuki Jimny, produced approximately from 1998 to 2018. The operation is very…
How to Replace the Auxiliary Belt on a Suzuki Jimny
How to Replace the Auxiliary Belt on a Suzuki Jimny
Suzuki Jimny (1998-2018 / Jb23, Jb33, Jb43, Jb53) Before you can start, open the bonnet of your Suzuki Jimny. Begin by loosening the tensioner by slightly unscrewing the fixing bolt. This will free t…
How to Fit Roof Bars on a Suzuki Jimny
How to Fit Roof Bars on a Suzuki Jimny
Suzuki Jimny (1998-2018 / Jb23, Jb33, Jb43, Jb53) Before you can begin, you need to exit the cabin of your Suzuki Jimny. Start by removing the plastic inserts located at the upper corners of the roof…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos