Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Stock Radio in the Tata Zest

Model: Tata Zest MK 1 - Years 2014-2019
Part: Car stereo

Today, we will see in this video tutorial how to remove and replace the stock radio with an Android type in the Tata Zest. First, get inside the vehicle and start by removing the plastic cover found on the sides of the radio, using something thin to pry it off; then unscrew the mounting screws found on the sides using a Phillips screwdriver, as shown in the video. At this point, disconnect the electrical connectors found at the back, remove the old radio, and replace it with the new one; modify the wiring as needed, following the video tutorial to the end!

Updated on 19 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Where Are the Fuses Located in the Tata Zest?
Where Are the Fuses Located in the Tata Zest?
Tata Zest (2014-2019 / MK 1) The fuses in the Tata Zest are located in dedicated fuse boxes installed in the vehicle. This type of vehicle has two fuse boxes. The first is locate…
How to Replace the Oil Filter on a Tata Zest?
How to Replace the Oil Filter on a Tata Zest?
Tata Zest (2014-2019 / MK 1) To replace the oil filter on a Tata Zest, open the hood to access the components inside the engine compartment. You will need to remove the plastic c…
How to Replace the Cabin Air Filter on Tata Zest
How to Replace the Cabin Air Filter on Tata Zest
Tata Zest (2014-2019 / MK 1) To replace the cabin air filter on the Tata Zest, you need to remove the panel on the side of the footwell on the driver's side, near the center cons…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos