Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to remove the steering wheel airbag of the Toyota Yaris

Model: Toyota Yaris Xp10 - Years 1999-2005
Part: Airbag

These short and simple instructions will guide us through the process of disassembling and replacing the steering wheel airbag of the Toyota Yaris. Firstly, we open the front driver's side door and start pressing on the rear holes of the steering wheel to release the airbag; then we disconnect the electrical connector of the airbag to remove it, as shown in the video. At this point, it will be possible to also remove the steering wheel by unscrewing the central screw; then we proceed to replace the steering wheel airbag with the new one, securing it properly on the steering wheel, following the video tutorial until the end!

Posted on 2 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Front Bumper of a Toyota Yaris
How to Remove the Front Bumper of a Toyota Yaris
Toyota Yaris (2011-2019 / Xp130) Start by opening the bonnet of your Toyota Yaris by pulling the designated release handle located at the bottom left of the steering column. Next, un…
How to Remove the Door Panel of a Toyota Yaris
How to Remove the Door Panel of a Toyota Yaris
Toyota Yaris (2020-2026 / MK 4) Before you start, open the front door of your Toyota Yaris. Begin by unclipping and removing the window switch controls, then disconnect the associat…
How to Fold Down the Rear Seats of a Toyota Yaris
How to Fold Down the Rear Seats of a Toyota Yaris
Toyota Yaris (2005-2011 / Xp90) Before starting, open the rear doors of your Toyota Yaris. Begin by pulling up the two hooks located at the upper corners of the rear seats, thus rel…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos