Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Bluetooth Extension Installation

Model: Toyota Rav 4 Xa30, MK 3 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Accessory kit

See other generations:
Video tutorial

This video shows you how to install a Bluetooth extension in your car. Once you have removed the relevant panels to access the car radio, also remove the climate controls. Proceed with the installation of the microphone, positioning it on the driver's side A-pillar; you need to run the microphone wire through the door seal on the driver's side and into the panel located under the steering wheel until you reach the car radio.

Once the Bluetooth extension is connected to your car radio and the appropriate connections are made, you can also attach the microphone wire. Perform a test to verify correct operation and reassemble everything.


Updated on 10 February 2026 by ScegliAuto


Related tutorials

How to Replace the Spark Plugs on a Toyota Rav4
How to Replace the Spark Plugs on a Toyota Rav4
Toyota Rav 4 (2000-2006 / MK 2, Xa20) Want to remove the spark plugs from your Toyota Rav4? Watch this video to find out how. Pull the lever to open the engine compartment and lift the fr…
How to Install Door Sills on a Toyota RAV4
How to Install Door Sills on a Toyota RAV4
Toyota Rav 4 (2019-2026 / MK 5, Xa50) The following steps will show you how to install the door sills on a Toyota RAV4, following the instructions below. First, open the car doors and tho…
Installing Interior Handle Lighting on Toyota RAV4 [USA]
Installing Interior Handle Lighting on Toyota RAV4 [USA]
Toyota Rav 4 (2019-2026 / MK 5, Xa50) Enhancing the interior of your car with an ambient light kit will make it look much more modern and appealing. You can purchase specific aftermarket …

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos