Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Exterior Door Handle on a Toyota Camry XV40

Model: Toyota Camry Xv40 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Handle

See other generations:
Video tutorial

This guide shows how to replace the exterior door handle on a Toyota Camry XV40. After removing the service light from the door, disconnect the trim piece from the mirror and the handle's backplate. Remove the inner cover of the door handle and take out the plastic clip on the inner side of the panel.

Remove the three Phillips screws and take off the inner door panel. Disconnect the electrical connectors and lock cables, and remove the insulating sheet from the door.

Remove the retaining clip of the lock actuator and, from the door side, take off the protective cap of the Torx T30 screw and the other screw from inside the door. Remove the lock cylinder and lever, and from inside the door, the mechanism.

Remove the seals and install the new kit. Reassemble the entire door panel and check the proper operation of the lock.


Updated on 11 May 2026 by ScegliAuto


Related tutorials

Where the Fuse Boxes are Located in the Toyota Camry XV40
Toyota Camry (2006-2013 / Xv40) In this video, you will see the location of the fuse boxes in the Toyota Camry XV40, produced between 2007 and 2011. The vehicle typically has two fu…
Where to Find the Fuse Box on the Toyota Camry XV40
Where to Find the Fuse Box on the Toyota Camry XV40
Toyota Camry (2006-2013 / Xv40) If you own a Toyota Camry XV40 (model year 2006-2013) and want to find the fuse box, just follow these steps. First, get inside the vehicle and reach…
Where to Find the Engine Fuse Box of the Toyota Camry XV40
Where to Find the Engine Fuse Box of the Toyota Camry XV40
Toyota Camry (2006-2013 / Xv40) If you have a Toyota Camry XV40 and want to locate the engine fuse box, follow the steps described below. First, lift the hood of your Toyota Camry, …

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos