Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Cabin Fan on a Toyota Rav 4 MK3

Model: Toyota Rav 4 Xa30, MK 3 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Blower motor

See other generations:
Video tutorial

In this short video, we will see the instructions on how to dismantle and replace the cabin fan motor on the Toyota Rav 4 third series. First, get inside the vehicle and start by removing the plastic side panel located at the bottom on the passenger side; then disconnect the electrical connector of the cabin fan, as shown in the video.

At this point, unscrew the screws of the fan using a Torx screwdriver; extract and replace the fan with the new one, using the original spare part. Finally, reassemble everything, following the video to the end!


Updated on 2 June 2026 by ScegliAuto


Related tutorials

How to Replace the Cabin Fan on a Toyota RAV 4?
How to Replace the Cabin Fan on a Toyota RAV 4?
Toyota Rav 4 (2006-2013 / Xa30, MK 3) To replace the cabin fan on a Toyota RAV 4, detach the retaining clips that secure the protection panel located just below the glove compartment. Onc…
Replacement of the cooling radiator of the Toyota RAV 4 2.0 VVT-I
Replacement of the cooling radiator of the Toyota RAV 4 2.0 VVT-I
Toyota Rav 4 (2006-2013 / Xa30, MK 3) Below we will see the instructions that will allow us to disassemble and replace the cooling radiator of the Toyota RAV 4 2.0 VVT-I. First, we open t…
How to Replace the Cabin Fan in a Toyota RAV4?
How to Replace the Cabin Fan in a Toyota RAV4?
Toyota Rav 4 (2013-2018 / Xa40, MK 4) In this tutorial, you will see how to replace the cabin fan in a Toyota RAV4, a very simple and quick operation. First, ensure that the key is not in…

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos