Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Wheel Bearing of the Toyota Yaris

Model: Toyota Yaris Xp90 - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011
Part: Bearing

See other generations:
Video tutorial

Here are the instructions to remove and replace the rear wheel bearing of the Toyota Yaris, following these simple steps. First, lift the vehicle at the rear and start by removing the wheel.

Then, remove the brake caliper and disc by unscrewing the fixing screws, as shown in the video. At this point, disconnect the electrical connector of the sensor and unscrew the central nut of the bearing to remove it, replacing it with the new one. Ensure the bearing is seated properly and then reinstall the braking system!


Updated on 30 June 2026 by ScegliAuto


Related tutorials

Replacing the rear wheel bearing on the Toyota Yaris 2 (XP90)
Replacing the rear wheel bearing on the Toyota Yaris 2 (XP90)
Toyota Yaris (2005-2011 / Xp90) In this video, see how to remove and replace the rear wheel bearing on the Toyota Yaris XP90, second generation, following the instructions below. Fi…
How to Replace the Front Wheel Bearing on a Toyota Yaris?
How to Replace the Front Wheel Bearing on a Toyota Yaris?
Toyota Yaris (1999-2005 / Xp10) To replace the bearing on a Toyota Yaris, loosen the bolts securing the front wheel corresponding to the bearing to be replaced and remove it complet…
How to Change the Rear Bearing on a 2005 Toyota Yaris
How to Change the Rear Bearing on a 2005 Toyota Yaris
Toyota Yaris (1999-2005 / Xp10) Replacing the rear hub bearing is straightforward as the bearing is sold complete with the hub; therefore, lift the vehicle, remove the wheel and bra…

Other guides you may be interested in

How to Open the Hood of the BMW X3

Today, you will learn how to open and close the hood of the BMW X3. To perform this simple operation, lift the hood release lever located next to the door seal on the driver’s side. After pulling the lever, you will notice that the hood will lift slightly. Position yourself in front of the hood and lift it after moving the internal lever from left to right. To keep the hood secure during maintenance, use the side support rod. To close the hood, simply let it fall back into place.

Watch the video!


by ScegliAuto

More videos