Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Sun Visor on a Toyota Venza

Model: Toyota Venza MK  1, Av10 - Years 2008-2017

If you need to replace the sun visor in your vehicle, follow the steps below and refer to this video. The procedure is the same for removing the driver side visor and the passenger side visor. First, use a plastic pry tool to detach the trim cover around the mounting pin on the roof. Use a screwdriver to unscrew the two screws under the plastic cover and pull the visor assembly towards you after detaching it from the pin on the opposite side. Then, take the new complete visor, reposition the screws, and reinstall them, finally reattaching the plastic cover to complete the job.

Updated on 1 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset the service light on the Toyota Venza 2
How to reset the service light on the Toyota Venza 2
Toyota Venza (2020-2026 / MK  2, Xu80) To complete the manual reset of the service light on the instrument panel of your second generation Toyota Venza, you must follow the steps described…
How to Replace the Remote Battery on a Toyota Venza
How to Replace the Remote Battery on a Toyota Venza
Toyota Venza (2020-2026 / MK  2, Xu80) To replace the remote battery on a Toyota Venza, pull the key out of its housing by using the lever located at the top of the device: this way, the k…
How to Replace the Key Battery in a 2021 Toyota Venza
How to Replace the Key Battery in a 2021 Toyota Venza
Toyota Venza (2020-2026 / MK  2, Xu80) Replacing the battery in your 2021 Toyota Venza smart key is a very simple maintenance task that takes just a few seconds to complete correctly. Here…

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos