Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Number Plate Bulb of the Toyota C-HR?

Model: Toyota C Hr Ax10, MK 1, Ax50 - Years: 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
Part: License plate light

See other generations:
Video tutorial

To replace the number plate bulb of the Toyota C-HR, open the rear hatch to allow access to pry off the internal trim panel near the light. Once this panel is removed, locate the bulb inside and disconnect it from the appropriate connector.

After removing the old bulb, connect the new one to its connector and insert it back into its housing. After installation, check that everything works correctly.


Updated on 5 October 2026 by ScegliAuto


Related tutorials

Replacement of the license plate lights of the Toyota CH-R.
Replacement of the license plate lights of the Toyota CH-R.
Toyota C Hr (2016-2023 / Ax10, MK 1, Ax50) In this short guide, we will go over the instructions that will allow us to disassemble and replace the license plate lights of the Toyota CH-R. Firs…
Replacing Number Plate Bulb on Toyota CHR
Replacing Number Plate Bulb on Toyota CHR
Toyota C Hr (2016-2023 / Ax10, MK 1, Ax50) Replacing the number plate bulbs on the Toyota CHR is very simple: the bulb holders are located in the strip just above the number plate itself, belo…
How to Replace the Front Headlight Bulb on a Toyota C-HR?
How to Replace the Front Headlight Bulb on a Toyota C-HR?
Toyota C Hr (2016-2023 / Ax10, MK 1, Ax50) To replace the front headlight bulb on a Toyota C-HR, open the bonnet to access the components located inside the engine compartment. Here, you will …

How to Open the Bonnet of a Toyota C-HR

To open the bonnet of a Toyota C-HR, get inside the vehicle and lift the lever with the bonnet symbol located under the steering wheel. After lifting the lever, you will notice that the bonnet rises a few centimetres. Position yourself in front of the bonnet, insert your hand into the gap, and move the small internal lever from right to left, then lift the bonnet. You can keep the bonnet open during maintenance by positioning it on the support rod. To close the bonnet, remove the support rod and let it drop back down.

Watch the video!


by ScegliAuto

More videos