Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Number Plate Bulb on Toyota CHR

Model: Toyota C Hr Ax50, MK 1, Ax10 - Years 2016-2023
Part: License plate light

Replacing the number plate bulbs on the Toyota CHR is very simple: the bulb holders are located in the strip just above the number plate itself, below the manufacturer's logo; access the bulb holders by opening the rear hatch and removing the caps on the plastic cover of the hatch: once the caps are removed, disconnect the power connector and then pull out the bulb holder to remove the bulb (it is a T10 bulb rated at 5W); it is recommended to install LED bulbs opting for those with CAN Bus, meaning with a resistance value that does not trigger any faults with the corresponding warning light.

Updated on 4 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the license plate lights of the Toyota CH-R.
Replacement of the license plate lights of the Toyota CH-R.
Toyota C Hr (2016-2023 / Ax50, MK 1, Ax10) In this short guide, we will go over the instructions that will allow us to disassemble and replace the license plate lights of the Toyota CH-R. Firs…
Replacing the Interior Light Bulbs in a Toyota C-HR
Replacing the Interior Light Bulbs in a Toyota C-HR
Toyota C Hr (2016-2023 / Ax50, MK 1, Ax10) Let's see how to replace the interior light bulbs in a Toyota C-HR with LED bulbs. Start with the lights above the rear-view mirror: use a flathead s…
How to Reset the Tyres on a Toyota C-HR
How to Reset the Tyres on a Toyota C-HR
Toyota C Hr (2016-2023 / Ax50, MK 1, Ax10) The video demonstrates how to reset the tyre pressure on a Toyota C-HR. The first step is to ensure the car is stationary, not in motion. Navigate th…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos