Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove a Starter Cylinder

Model: (Various brands) Various

In this guide, you will learn how to remove a starter cylinder. Start by removing the screws securing the lower cover of the steering column and slide the cover downwards. Next, move the steering column to remove the upper cover as well. You will now see the ignition lock; carefully remove the small antenna that reads the key code (a small black plastic ring), insert the metal key into the cylinder, and after locating the release pin of the ignition lock, press it with a screwdriver while simultaneously turning the key and pulling the starter cylinder out of its housing.

Updated on 6 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Ignition Barrel
Replacing the Ignition Barrel
(Various brands) Various To replace the ignition barrel, first remove the screws holding the covers at the back of the steering wheel. Use a screwdriver and be patient to avo…
Disassembly of a Starter Motor
Disassembly of a Starter Motor
(Various brands) Various The first step when disassembling a starter motor is to remove the two long fixing screws located on the sides, then unscrew the 13 mm bolt a little …
How to Replace the Starter Motor on a Burgman 400 Scooter
(Various brands) Various This video tutorial shows how to replace the starter motor on a Burgman 400 scooter by following some simple steps that will allow you to work indepe…

Other guides you may be interested in

    Frequently Asked Questions

    • Vari - Opinions on Nankang AW-6 Cross Season tyres Read answer
    • Vari - How does the BRC LPG switch work? Read answer
    • Vari - What problems can a Piaggio MP3 give? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos