Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

The Crucial Function of the Two Lambda Sensors

Model: (Various brands) Various
Part: Oxygen sensor

If your vehicle experiences hesitation during acceleration, the issue may be due to the lambda sensor, located on the exhaust before the catalyst, which checks the amount of oxygen present in the exhaust gases. This allows it to verify the air-fuel ratio: it informs the ECU, which in turn adjusts the correct air-fuel ratio. If the lambda sensor has issues, it will not only trigger the warning light but also cause problems during acceleration, as it no longer reads the oxygen level before the catalyst, incorrectly informing the ECU. There is also a lambda sensor after the catalyst, which checks that the catalyst is functioning correctly; if it is clogged or dirty, the yellow warning light will illuminate immediately.

Updated on 5 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How a Lambda Sensor Works
How a Lambda Sensor Works
(Various brands) Various How does a lambda sensor work? A 4-wire sensor consists of two elements: the first is the heating element, which is simply a resistor, and the second…
How to Test Fuses with a Multimeter to Check if They Are Faulty
How to Test Fuses with a Multimeter to Check if They Are Faulty
(Various brands) Various To test the fuses, set the multimeter to the "Ohm" function (200 or 20k Ohm); connect the probes, black to COM and red to Ohm. Test the probes: touch…
How to Replace the Lambda Sensor on a Biemme JDM Project
How to Replace the Lambda Sensor on a Biemme JDM Project
(Various brands) Various Today, with the help of this video tutorial, you will learn how to replace the lambda sensor on the Biemme JDM Project. This task is not difficult to…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos