Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Oil Warning Light on the Yamaha X Max 300

Model: (Various brands) Various
Part: Service warning light

To reset the oil warning light on the Yamaha X Max 300, follow these steps: Turn off the ignition of the X Max, press and hold the mode and set buttons, then turn on the ignition while keeping the mode and set buttons pressed for two seconds. At this point, the reset is complete and the oil warning light will be off. This procedure is very simple and quick, requiring no special tools. Perform this procedure only after changing the oil if the light remains on for any reason, possibly because the sensor has a delay in communicating with the ECU, causing the error to stay illuminated.

Updated on 11 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Where to Find the Fuse Box on the Yamaha X Max 300
Where to Find the Fuse Box on the Yamaha X Max 300
(Various brands) Various If you are looking for the fuse box located inside your Yamaha X Max 300 but have not yet found it, just carefully read the following mini guide and …
How to Reset the Oil Change Warning Light on the Yamaha X-max
How to Reset the Oil Change Warning Light on the Yamaha X-max
(Various brands) Various After changing the engine oil and the corresponding filter on this scooter, you need to reset the oil change warning light on the dashboard. Follow t…
How to Reset the Oil Light on the Yamaha Xmax 250
How to Reset the Oil Light on the Yamaha Xmax 250
(Various brands) Various Resetting the oil light on the 2007 Yamaha Xmax 250 is a very simple operation that you can carry out independently. It is important to reset the lig…

    Frequently Asked Questions

    • Vari - What does the Service light on the KTM Duke 200 indicate? Read answer
    • Vari - How do you reset the Service light on an Aixam? Read answer

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos