Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Service Light on the Great Wall Poer

Model: (Various brands) Various
Part: Service warning light

To reset the maintenance interval on the Great Wall Poer, you need a diagnostic tool capable of resetting the service light from the instrument cluster. Get inside the vehicle and connect the tool; select the make, model, and engine type, then navigate to the error codes and the service section, following the guided procedure to perform the reset, as shown in the video. Wait for the light to turn off before disconnecting the tool and starting the engine!

Updated on 29 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Cabin Air Filter of the Great Wall Poer
Replacing the Cabin Air Filter of the Great Wall Poer
(Various brands) Various To prevent dust from entering the ventilation circuit of the Great Wall Poer, a specific filter has been installed on the intake that must be replace…
How to Change the Fuel Filter of the Great Wall V240
How to Change the Fuel Filter of the Great Wall V240
(Various brands) Various In this video tutorial, you will see the main instructions that will allow you to remove and replace the fuel filter of the Great Wall V240. First, l…
How to Replace the Remote Battery of the Great Wall Haval
How to Replace the Remote Battery of the Great Wall Haval
(Various brands) Various Briefly, this video will show step-by-step instructions on how to disassemble and replace the battery of the Great Wall Haval key remote. First, take…

Other guides you may be interested in

    Frequently Asked Questions

    • Vari - What does the Service light on the KTM Duke 200 indicate? Read answer
    • Vari - How do you reset the Service light on an Aixam? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos