Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Passat
    4. : Hand brake

Volkswagen Passat - Hand brake

Volkswagen Passat (2005-2010 / B6, 3C)
How do you reset the handbrake of the Volkswagen Passat?
To reset the handbrake of the Volkswagen Passat, you need to connect a diagnostic tool to the OBD port of the vehicle. This port can be found on the lower left …read all…
Posted on 15 February 2024 by ScegliAuto
Volkswagen Passat (2010-2014 / B7)
How to activate or deactivate the electronic handbrake on Volkswagen Passat
We see in this guide the instructions on how to deactivate the electronic handbrake of the Volkswagen Passat, by following these simple steps. First we get on …read all…
Posted on 27 December 2022 by ScegliAuto
Volkswagen Passat (2010-2014 / B7)
How do you replace the handbrake button on your Volkswagen Passat?
In order to replace the Volkswagen Passat handbrake button, you need to lift the gear lever gaiter, so that you can leverage inside its housing to detach the …read all…
Posted on 30 November 2022 by ScegliAuto
Volkswagen Passat (2005-2010 / B6, 3C)
How do you reset the electronic handbrake on the Passat B6?
In order to reset the electronic handbrake of the Volkswagen Passat B6 you have to pull out the button that allows the handbrake to be engaged, removing it …read all…
Posted on 17 April 2024 by ScegliAuto
Volkswagen Passat (1996-2005 / 3BG, B5)
Handbrake operation clarifications
Once the engine is switched off, the hydraulic system that activates the brake calipers is deactivated: in order to lock the rear wheels by engaging the …read all…
Posted on 1 August 2023 by ScegliAuto
Cigarette Lighter (4) Airbags (1) Alternator (2) Loudspeaker (7) Shock absorbers (1) Air conditioning (3) Car stereo (24) Battery (25) Air Vents (6) Bushings (1) Arm (5) Gearbox (2) Spark plugs (6) Glow plugs (6) Bodywork (4) Glove box (4) Control unit (1) Key (78) Locking the trunk (2) Timing belt (27) V-belt (5) Air conditioning (12) Air conditioning controls (2) -board computer (18) Checks and maintenance (164) Throttle body (2) Dashboard (9) Gearshift gaiter (3) Drive shaft boot (1) Bearing (3) Brake discs (5) Rear bench seat (2) Headlight (14) Tail light (8) Fog lights (5) Particulate filter (1) Air filter (15) Cabin air filter (24) Petrol filter (1) Diesel filter (9) Oil filter (6) Hand brake (5) Clutch (2) Injectors (1) Window lift switch (5) Accessory Kit (2) Xenon headlight kit (1) Light bulb (14) Side turn signal light bulb (3) Headlight bulb (23) Rear light bulb (5) Interior lights ceiling light bulb (6) Antifreeze liquid (3) Dashboard light (3) License plate light (3) Third brake light (1) Handle (3) Muffler (1) Engine (11) Window motor (4) Starter motor (4) Gear oil (3) Engine oil (12) Door panel (29) Windshield (1) Front bumper (10) Rear bumper (3) Brake pads (12) Hydraulic pistons (5) Tires (8) Gear Shift Knob (4) Pump (5) Fuel pump (11) Door (2) Push button (2) Window lift button (2) Instrument cluster (32) Radiator (4) Passenger compartment heating radiator (17) Wheel (3) Fuse box (64) Seat (16) Drive shaft (4) Crankshaft RPM sensor (1) Coolant temperature sensor (2) Parking sensors (1) Lock (4) Suspensions (5) Outside rearview mirror (17) Interior rearview mirror (1) Engine mount (1) Windscreen wipers (5) Thermostat (11) Steering rods (3) Central tunnel (2) Turbine (5) Valve (1) EGR valve (4) Interior blower (2) Side window (1) Steering wheel (1)

How to reset the service in the Opel Antara?

As we can see in this tutorial, resetting the service in the Opel Antara is an extremely simple and fast operation. Before proceeding, of course, we must have completed all the planned maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel, not the engine. At this point, we release the accelerator and press it 3 consecutive times, always all the way. We then restart the panel to verify that the procedure has been carried out correctly.

Watch the video!


by ScegliAuto

More videos