Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install or Replace Parking Sensors on the Volkswagen Golf

Model: Volkswagen Golf Golf 6, MK 6, 5K1, Golf VI - Years: 2008, 2009, 2010, 2011, 2012
Part: Parking sensors

See other generations:
Video tutorial

Today's instructions will guide you on how to install or replace the parking sensors on the Volkswagen Golf. The rear parking sensors are installed on the bumper, so first, remove it by unscrewing all the fixing screws; then prepare the parking sensors if this is the first installation, or remove them if you need to repair or replace a single sensor, as shown in the video.

After reassembling the sensors, verify their correct operation!


Updated on 29 October 2026 by ScegliAuto


Related tutorials

How to Replace the Parking Sensors on a Volkswagen Golf?
How to Replace the Parking Sensors on a Volkswagen Golf?
Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) To replace the parking sensors on a Volkswagen Golf, you need to completely remove the rear bumper of the car: to do this, unscrew the screws located…
How to replace the parking sensors on the Volkswagen Golf
How to replace the parking sensors on the Volkswagen Golf
Volkswagen Golf (2008-2012 / Golf 6, MK 6, 5K1, Golf VI) In this video tutorial, you will see how to replace or install the parking sensors on the Volkswagen Golf, following the instructions below. First, o…
Deactivate Parking Sensors on VW Golf 7
Deactivate Parking Sensors on VW Golf 7
Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) Deactivating the parking sensors on a Volkswagen Golf 7 is a very simple procedure. To do this, get into the car, turn on the instrument cluster and …

    Frequently Asked Questions

    • Golf 2008-2012 - Where is the parking sensor control unit of the Golf 6 located? Read answer

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos