Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the parking sensors on the Volkswagen Golf

Model: Volkswagen Golf Golf 6, MK 6, 5K1, Golf VI - Years: 2008, 2009, 2010, 2011, 2012
Part: Parking sensors

See other generations:
Video tutorial

In this video tutorial, you will see how to replace or install the parking sensors on the Volkswagen Golf, following the instructions below. First, open the boot and start by removing the rear bumper; to do this, remove the seal from the boot and unscrew all the screws found on the top and bottom of the bumper, as well as those located on both sides of the wheel arches, as shown in the video.

At this point, unclip and remove the parking sensors by disconnecting the electrical connector; replace them with the new ones or proceed with the installation, following the video to the end!


Updated on 11 May 2026 by ScegliAuto


Related tutorials

How to Install or Replace Parking Sensors on the Volkswagen Golf
How to Install or Replace Parking Sensors on the Volkswagen Golf
Volkswagen Golf (2008-2012 / Golf 6, MK 6, 5K1, Golf VI) Today's instructions will guide you on how to install or replace the parking sensors on the Volkswagen Golf. The rear parking sensors are installed o…
How to Replace the Parking Sensors on a Volkswagen Golf?
How to Replace the Parking Sensors on a Volkswagen Golf?
Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) To replace the parking sensors on a Volkswagen Golf, you need to completely remove the rear bumper of the car: to do this, unscrew the screws located…
Deactivate Parking Sensors on VW Golf 7
Deactivate Parking Sensors on VW Golf 7
Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) Deactivating the parking sensors on a Volkswagen Golf 7 is a very simple procedure. To do this, get into the car, turn on the instrument cluster and …

Other guides you may be interested in

    Frequently Asked Questions

    • Golf 2008-2012 - Where is the parking sensor control unit of the Golf 6 located? Read answer

How to open the bonnet on a Volkswagen Golf?

In this tutorial, you will see how to open the bonnet on a Volkswagen Golf MK4. This is a very simple operation that follows the standard procedure. First, open the driver's door, then locate the lever in the lower left area and pull it. Next, move to the front of the vehicle, lift the bonnet slightly, and find the second lever located just above the Volkswagen logo. At this point, simply pull it towards you, fully open the bonnet, and secure it with the prop rod. To close it, gently push it down.

Watch the video!


by ScegliAuto

More videos