Do it yourself
Frequently asked questions about cars and motorcycles

How to replace the rear headlight bulb of the VW Polo

Model: Volkswagen Polo Polo 5, Polo V, MK 5, MK V, 6R - Years 2009-2017
Part: Tail light bulb

The following video tutorial will show us the steps to replace the rear headlight bulb of a Volkswagen Polo MK 5 model. The first step is to open the trunk of the vehicle. The second step is to remove the side carpet, corresponding to the right and left headlight. The third step is to disconnect the connector from the headlight. The fourth step is to remove the headlight from its housing. The fifth step is to open the headlight dome in order to remove the bulbs inside and proceed with the replacement. The sixth step is to close the dome cap, insert the headlight into its housing, and reconnect the connector. After placing the carpet back, we can proceed by following the same steps for the replacement of the left headlight bulb.

Posted on 11 January 2025 by ScegliAuto

Video tutorial

Related tutorials

Volkswagen Polo (2009-2017 / Polo 5, Polo V, MK 5, MK V, 6R) To replace the rear light bulb on a Volkswagen Polo, open the boot and lift the side carpet in line with the light. Underneath, you will find a pin t…
Volkswagen Polo (2009-2017 / Polo 5, Polo V, MK 5, MK V, 6R) To replace the rear light bulb on a Volkswagen Polo, open the tailgate and then detach the side trim of the boot, corresponding to the light: beneath…
Volkswagen Polo (2001-2009 / MK IV, Polo IV, Polo 4, MK 4, 9N) To replace the rear headlight bulb of a Volkswagen Polo, start by opening the rear hatch. Inside, locate the access panel to the rear headlight compa…

Other guides you may be interested in

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos