|
Do it yourself
| |||
| ||||
Volkswagen Tiguan, DIY: how to remove the trim of the pillar.
Model: Volkswagen Tiguan
5N, MK 1
- Years 2007-2016
To remove the trim from pillar A on the Volkswagen Tiguan, open the front door and work carefully to avoid damaging the clips. Start by gently detaching the rubber seal of the door along the edge of the pillar to free the profile of the panel. At this point, grasp the trim at the top, near the headliner, and pull inward with decisive but controlled movements until the pressure fittings release. Once the top is free, guide the panel by rotating it and pulling it upward to detach it from the bottom side near the dashboard as well. Before completely removing it, locate the clear plastic safety latch connected to the body: rotate it and pull it out using pliers, then fully separate the trim. During this operation, be cautious of the curtain airbag area behind the pillar. For reassembly, first reinsert the plastic latch into its hole, align the panel in its seat, and press along the edge until all the clips snap into place, then reposition the door seal on the Tiguan.
Posted on 23 November 2025 by ScegliAuto
Video tutorial
Related tutorials
Volkswagen Tiguan
(2007-2016 /
5N, MK 1)
Today we will see the instructions that will allow us to disassemble and remove the inner lining of the rear door of the Volkswagen Tiguan. First, we…
Volkswagen Tiguan
(2007-2016 /
5N, MK 1)
In this guide, we will see the main instructions that will allow us to disassemble and replace the trunk lock of the Volkswagen Tiguan. First, we ope…
Volkswagen Tiguan
(2007-2016 /
5N, MK 1)
Below we will see step-by-step instructions on how to disassemble and replace the rear tailgate lock of the Volkswagen Tiguan. First, we open the rea…
Other guides you may be interested in
|
How to Repair the Key Spring of the Peugeot 207?
Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.095
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |