Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Rear Shock Absorbers

Model: Volkswagen Golf Golf IV, Golf 4, MK 4 - Years: 1997, 1998, 1999, 2000, 2001, 2002, 2003
Part: Shocks

See other generations:
Video tutorial

Shock absorbers should be replaced when they no longer perform their function, regardless of the mileage. To replace them, lift the vehicle and secure it. Remove the wheel and position a jack or hydraulic jack under the spring support to lift it slightly.

Unscrew the two retaining bolts of the shock absorber with a 15mm spanner. If the bolts are seized, use a penetrating spray, wait for it to take effect, and apply force on the spanner.

Remove the discharged shock absorber and fit the new shock absorber, ensuring it is of the same type. It is advisable to replace the fixing bolts; if not, clean the old ones thoroughly and grease them.

Use a torque wrench to tighten the bolts. Conduct a road test to verify proper functioning.


Updated on 6 February 2026 by ScegliAuto


Related tutorials

Checking the Rear Shock Absorber Knock
Checking the Rear Shock Absorber Knock
Volkswagen Golf (2003-2008 / Golf 5, MK 5, Golf V) If you hear a knock coming from the rear wheels while driving over rough terrain, it is likely due to the failure of the rear shock absorber mounts; …
Instructions for Replacing Rear Shock Absorbers
Instructions for Replacing Rear Shock Absorbers
Volkswagen Golf (1991-1997 / MK 3, Golf III, Golf 3) .. Replacing the rear shock absorbers is relatively straightforward as the spring and damper are separate,.. …
Replacing Rear Shock Absorbers on Volkswagen Golf 6
Replacing Rear Shock Absorbers on Volkswagen Golf 6
Volkswagen Golf (2008-2012 / Golf 6, MK 6, 5K1, Golf VI) In this video tutorial, you will see how to replace the rear shock absorbers on a Volkswagen Golf 6. First, remove the rear wheel and lift the car. T…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos