Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Replacing Rear Shock Absorbers

Model: Volkswagen Golf MK 3, Golf III, Golf 3 - Years: 1991, 1992, 1993, 1994, 1995, 1996, 1997
Part: Shocks

See other generations:
Video tutorial

Replacing the rear shock absorbers is relatively straightforward as the spring and damper are separate, so there is no need for special clamps to move the spring from the old to the new shock absorber; however, it may happen, as shown in the video, that the mounting bolt of the shock absorber to the rear axle support refuses to come off (common if the vehicle has been driven on snowy roads covered in salt): you will need to be resourceful to remove it without causing damage; a first step is to cut the eye of the shock absorber to extract it from its seat; at this point, remove the bolt and you could either use a blowtorch as shown in the video (but personally, I would avoid using open flames near the fuel tank) or a grinder with a cutting disc.

Then proceed in reverse for the installation of the new shock absorbers.


Updated on 16 February 2026 by ScegliAuto


Related tutorials

Checking the Rear Shock Absorber Knock
Checking the Rear Shock Absorber Knock
Volkswagen Golf (2003-2008 / Golf 5, MK 5, Golf V) If you hear a knock coming from the rear wheels while driving over rough terrain, it is likely due to the failure of the rear shock absorber mounts; …
Instructions for Replacing Rear Shock Absorber
Instructions for Replacing Rear Shock Absorber
Volkswagen Golf (1997-2003 / Golf IV, Golf 4, MK 4) To replace the rear shock absorbers (it is advisable to replace them in pairs), lift the vehicle on a lift and remove the rear wheel; place a jack un…
Replacing Rear Shock Absorbers
Replacing Rear Shock Absorbers
Volkswagen Golf (1997-2003 / Golf IV, Golf 4, MK 4) To replace the rear shock absorbers, lift the vehicle, remove the rear wheel, apply a support jack under the suspension, and proceed to remove the up…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos