Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Lambda Sensor Replacement Instructions

Model: Volkswagen Passat 3BG, B5 - Years: 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
Part: Engine

See other generations:
Video tutorial

The lambda sensor can detect the concentration of oxygen in the exhaust gases; by comparing the oxygen present in the ambient air, measured at the other end of the sensor, the amount of air in the exhaust gases is indirectly determined. The sensor then transmits this information via an electrical signal to the ECU (engine control unit), which regulates the intake of fuel and air into the combustion chamber: proper functioning is therefore absolutely essential for the engine's regular operation and especially for fuel consumption.

It is recommended to replace the sensor when the engine is cold and to obtain the appropriate open-ended spanner to fit despite the cable; to access the sensor, remove the coolant reservoir, detach the sensor, disconnect the connector, and proceed in reverse for the installation of the new one.


Updated on 15 February 2026 by ScegliAuto


Related tutorials

Position and replacement of the oxygen sensor on the Volkswagen Passat B7
Position and replacement of the oxygen sensor on the Volkswagen Passat B7
Volkswagen Passat (2010-2014 / B7) In this video, we will see where and how to change the oxygen sensor on a Volkswagen Passat 2011/2019. In this version, there are two lambda sensors.…
Where are the fuses located in the Volkswagen Passat?
Where are the fuses located in the Volkswagen Passat?
Volkswagen Passat (2005-2010 / B6, 3C) The fuse boxes of the Volkswagen Passat are responsible for containing the fuses that regulate the operation of the devices installed on the vehicle:…
Replacement of the timing belt of the Volkswagen Passat 2.0 TDI
Replacement of the timing belt of the Volkswagen Passat 2.0 TDI
Volkswagen Passat (2010-2014 / B7) Let's see the directions that will show us the procedure for disassembling and replacing the timing belt of the Volkswagen Passat 2.0 TDI. First, we …

How to Open the Hood of the BMW X3

Today, you will learn how to open and close the hood of the BMW X3. To perform this simple operation, lift the hood release lever located next to the door seal on the driver’s side. After pulling the lever, you will notice that the hood will lift slightly. Position yourself in front of the hood and lift it after moving the internal lever from left to right. To keep the hood secure during maintenance, use the side support rod. To close the hood, simply let it fall back into place.

Watch the video!


by ScegliAuto

More videos