Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Passat
    4. : How to disassemble the Volkswagen Passat parking sensor control unit

Volkswagen Passat - Video tutorial

Model: Volkswagen Passat B6, 3C - Years 2005-2010
Part: Control unit
Operation: How to disassemble the Volkswagen Passat parking sensor control unit

In this guide, let's find out the main steps that will allow us to disassemble and replace the parking sensor control unit on the Volkswagen Passat. First of all, we open the front door, driver's side, and start by disassembling the plastic cover that we find on the side; we find the parking sensors control unit inside, as shown in the video. At this point we disconnect the electrical connectors to remove it, removing the fixing clips; replace it with the new one and reassemble everything (the electronic board is repaired in the video).


Posted on 15 December 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Passat 2010-2014 - Where is the glow plug control module located in the Volkswagen Passat? Read Answer
    • Passat 2010-2014 - How much does it cost to replace the Volkswagen Passat ECU? Read Answer
    • Passat 2010-2014 - Where is the Volkswagen Passat convenience control unit located? Read Answer
    • Passat 2010-2014 - Where is the ECU of the Volkswagen Passat located? Read Answer
    • Passat 2005-2010 - How to replace the parking sensor control unit in the Volkswagen Passat? Read Answer
    • Passat 2005-2010 - Where is the ECU of a Volkswagen Passat located? Read Answer
    • Passat 1996-2005 - How much does the ECU of a Volkswagen Passat cost? Read Answer

How to open the bonnet of the Volkswagen Polo

Let's see in this short and simple guide the instructions that will allow us to open the bonnet of the Volkswagen Polo. First of all we open the front door, on the driver's side, and start pulling the opening lever of the engine hood, in order to open the lock; then let's move to the front of the vehicle and unhook the tab that we find on the central part, above the manufacturer's emblem, as shown in the video. At this point we block the bonnet with the lateral rod; then we accompany the bonnet down to close it again!

Watch the video!


by ScegliAuto

More videos