Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : Disassembly of the front headlight lamps of the Volkswagen Polo.

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo 6, MK VI, AW1, MK 6, Polo VI - Years 2017-2024
Part: Headlight
Operation: Disassembly of the front headlight lamps of the Volkswagen Polo.

Let's see how to replace the front headlight bulbs of the Volkswagen Polo. We open the engine hood and, if the affected headlight is on the driver's side, we need to secure it, as the bracket above the headlight, which we need to remove, is the base of the fixing rod. After removing the four screws that hold it, we need to detach the windshield washer fluid refill tube and the hood opening cable; we can then proceed to remove the bracket. This gives us access to the back of the headlight where the access caps for the bulbs are located: for the high beam, we remove the cap, disconnect the electrical connector, unlock the metal clip, and then we can remove the bulb. For the low beam, the job is more complicated due to the tighter space, but we won't have a metal clip to remove.


Posted on 11 October 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Polo 2001-2009 - How do you replace the front headlight of the Volkswagen Polo 8? Read Answer
    • Polo 2001-2009 - How much does the right headlight of a Volkswagen Polo cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos