Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How to remove the door panel of the 9th generation Polo

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo 4, MK 4, Polo IV, 9N, MK IV - Years 2001-2009
Part: Door panel
Operation: How to remove the door panel of the 9th generation Polo

How to remove the door handle of your Polo? This video shows you how to proceed. Before starting the disassembly work, let's disconnect the battery terminals in the front engine compartment. With a plastic spatula we go to leverage the handle that includes the window lifter buttons, disconnect the power cables. To unscrew the torx screws located under the inside door handle, use a screwdriver, being careful not to scratch it. Using the plastic spatula, unhook all the clips by levering around the entire perimeter of the door panel, then pull it away by grabbing it with your hands. Now we release the cable of the opening lever, the clamps of the window lifters and the speakers. Let's not lose all the interlocking clips placed behind the plastic panel disassembled first.


Posted on 27 September 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Polo 1994-2003 - How do you remove the Volkswagen Polo door panel? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos