Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the rear headlight bulbs of the Volvo XC70.

Model: Volvo Xc70 MK 3 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016
Part: Tail light bulb

See other generations:
Video tutorial

Below we will see the information that will allow us to disassemble and replace the bulbs of the rear headlight of the Volvo XC70. First, we open the rear hatch of the trunk and begin to disassemble and remove the inner plastic panel, then unscrewing the fixing screws of the headlight; then we disconnect the electrical connector of the bulbs, as shown in the video.

At this point, we separate the bulb holder from the light fixture, removing and replacing any faulty bulbs with new ones (having the same fitting); finally, we reassemble the headlight and the inner lining of the rear hatch!


Posted on 25 February 2025 by ScegliAuto


Related tutorials

Replacing the Rear Light on the Volvo XC70
Replacing the Rear Light on the Volvo XC70
Volvo Xc70 (2000-2007 / MK 2) Today, we will go through the steps to remove and replace the rear light on the Volvo XC70. First, open the tailgate and start unscrewing the fixing …
Replacing Rear Light Bulbs on a Volvo V70
Replacing Rear Light Bulbs on a Volvo V70
Volvo Xc70 (2000-2007 / MK 2) See how to replace the rear light bulbs on a Volvo V70. Open and lift the boot lid. Using a screwdriver, remove the plastic panel covering the rear l…
How to Remove the Front Headlamp of the Volvo XC70
Volvo Xc70 (2007-2016 / MK 3) Remove and lift the front bonnet of the car, then locate the metal clips above the front of the headlamp. Once you have removed the two metal clips, …

Other guides you may be interested in

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos