Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volvo
    3. :
  3. V60
    4. : How do I reset the Volvo V60 service light?

Volvo V60 - Video tutorial

Model: Volvo V60 MK 1 - Years 2010-2018
Part: Checks and maintenance
Operation: How do I reset the Volvo V60 service light?

To reset the Volvo V60 Service light, you need to turn on the instrument panel and navigate the menu using the left lever and the relative OK button. Voice T2 must be selected; when item T2 has been selected, the START / STOP key and the OK key must be pressed at the same time. The two buttons must be held until the warning light immediately below the speedometer starts to flash. When the light starts flashing, it will be possible to release the two buttons. To verify that the Service warning light has been reset, the instrument panel must be switched off and on again.


Posted on 26 February 2024 by ScegliAuto

    Frequently Asked Questions

    • V60 2018-2025 - When should I do the maintenance check-ups for the Volvo V60? Read Answer
    • V60 2018-2025 - How to reset the service light on the Volvo V60? Read Answer
    • V60 2018-2025 - How often should the Volvo V60 be serviced? Read Answer
    • V60 2018-2025 - How many km do you need to service the Volvo V60 d2? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos