Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Engine Gasket

Model: Volvo S70 MK 1 - Years: 1996, 1997, 1998, 1999, 2000
Part: Engine

Video tutorial

The heart of the engine is the car gasket that encloses the movement of the pistons, preventing oil from coming into contact with water. These gaskets are usually made of cast iron, and failures can occur at the welds.

The cylinder head gasket is such an important component that when you notice it is damaged, it should be replaced immediately. To proceed with the replacement, check that the engine block has not been deformed, then clean the surface of the cylinder head and engine block as well as the bolt seats that secure the cylinder head cover to the engine block.

You can then apply the new gasket to the engine, tightening the bolts with a ratchet spanner.


Updated on 13 February 2026 by ScegliAuto


Related tutorials

Replacing the Valve Stem Seal
Replacing the Valve Stem Seal
Volvo S70 (1996-2000 / MK 1) This video demonstrates how to replace the valve stem seals on the engine of a Volvo S70. In the video, the cylinder head is already removed and read…
Replacement of the Rocker Cover Gasket
Replacement of the Rocker Cover Gasket
Volvo S70 (1996-2000 / MK 1) When replacing the rocker cover gasket, it is very important to thoroughly clean the gasket seat on both the cylinder head side and the cover side, r…
Replacing the Intake Manifold Gasket
Replacing the Intake Manifold Gasket
Volvo S70 (1996-2000 / MK 1) Before applying the new gasket to the intake manifold, it is crucial to clean the surface on both the manifold and cylinder head sides, removing any …

Other guides you may be interested in

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos