Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volvo
    3. :
  3. S40
    4. : Sill lighting bulb replacement

Volvo S40 - Video tutorial

Model: Volvo S40 MK 1 - Years 1995-2004
Part: Light bulb
Operation: Sill lighting bulb replacement

In correspondence with the pedals on the driver's side, there is a light bulb which illuminates the seat of the pedals itself: in order to replace this light bulb it is necessary to unhook the transparent plastic lens which also acts as a lamp holder, unhook the original light bulb (so-called torpedo attachment) and insert the new one and then hang up the lens. You could also opt for an LED type bulb: in this case it is advisable to check that it turns on because otherwise it must be rotated 180 degrees since the LEDs have a power supply polarity to be respected.


Posted on 27 August 2023 by ScegliAuto



Side turn signal bulb replacement
Volvo S40 (1995-2004 / MK 1) The signal lamps, in a car, are very important so it is always advisable to carry out a check. Should the light of a direction indicator burn out, it
Third brake light bulb replacement
Volvo S40 (1995-2004 / MK 1) In order to avoid rear-end collisions, it is advisable to also check the stop lamps. If the third brake light is blown, it should be replaced. The op
Replacement of T5 climate control light bulbs
Volvo S40 (1995-2004 / MK 1) First remove the knobs for adjusting the climate controls by simply pulling them outwards. Using a small fixed screwdriver or a plastic lever for coa

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos