Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Alfa Romeo
    3. :
  3. 147
    4. : How to remove Alfa Romeo 147 window regulator button

Alfa Romeo 147 - Video tutorial

Model: Alfa Romeo 147 MK 1 - Years 2000-2010
Part: Window lift button
Operation: How to remove Alfa Romeo 147 window regulator button

How to remove the window control panel located on the passenger side panel of an Alfa Romeo 147? This video explains how to proceed. Before starting the disassembly work, let's disconnect the battery terminals in the engine compartment. With a screwdriver we go to unscrew the tightening screws placed under the push-button panel of the door panel. Once you have unscrewed all the fastening screws of the push button panel, pry it up and extract it out of the door panel. Finally we disconnect the power cables with a screwdriver. We replace the push button panel and reassemble everything.


Posted on 7 October 2023 by ScegliAuto



How do you replace the brake button in the Alfa Romeo 147?
Alfa Romeo 147 (2000-2010 / MK 1) This video shows how to replace the button on the handbrake lever. The car used in this clip is an Alfa Romeo 147, but the same procedure is also val
How to remove the front bumper of an Alfa Romeo 147
Alfa Romeo 147 (2000-2010 / MK 1) Before starting, we will have to open the front hood of our Alfa Romeo 147. So let's start by unscrewing and removing all the screws and all the bolt
How to replace the window regulator on Alfa Romeo 147
Alfa Romeo 147 (2000-2010 / MK 1) To reach the push button panel it will obviously be necessary to remove the door panel, to do so it will be necessary to remove the cap behind the ha

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos