Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Alfa Romeo
    3. :
  3. 147
    4. : How to remove the Alfa Romeo 147 battery

Alfa Romeo 147 - Video tutorial

Model: Alfa Romeo 147 MK 1 - Years 2000-2010
Part: Battery
Operation: How to remove the Alfa Romeo 147 battery

Is the battery of our Alfa Romeo damaged? Let's see how to replace the battery. We open the car door and pull up the engine compartment opening lever located at the bottom left of the dashboard and lift up the front bonnet, releasing the locking lever of the same with the fingers, then we put it in safety. We open the engine compartment, the battery is found to the right of the engine. We disassemble the locking pins of the battery terminals. We remove the battery from the engine compartment and replace it with a new one (same voltage). We close the bonnet at the end of the maintenance. We turn on the vehicle and test the battery.


Posted on 2 December 2023 by ScegliAuto



Where is the Alfa Romeo 147 fuse box located
Alfa Romeo 147 (2000-2010 / MK 1) If you cannot find the position in which the fuse box of your Alfa Romeo 147 is installed then all you have to do is pay attention to the following m
How to remove the front bumper of an Alfa Romeo 147
Alfa Romeo 147 (2000-2010 / MK 1) Before starting, we will have to open the front hood of our Alfa Romeo 147. So let's start by unscrewing and removing all the screws and all the bolt
How to replace the clutch pump in the Alfa Romeo 147?
Alfa Romeo 147 (2000-2010 / MK 1) In this tutorial, we can see how to replace the clutch pump in the Alfa Romeo 147, a very simple and fast operation. First of all, we open the engine

Other guides that may interest you

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos