Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Removing the Front Driveshaft on Alfa Romeo 147

Model: Alfa Romeo 147 MK 1 - Years 2000-2010
Part: Axle shaft

In this video, follow the essential instructions to remove the front driveshaft to replace its oil seal on an Alfa Romeo 147. First, lift the vehicle and remove the front wheel; then remove the gearbox oil bolt, allowing it to drain into a container. Next, proceed to remove the hub by unscrewing the bolts from the control arm ball joints; once the braking system is separated from the control arm, unscrew the three bolts of the driveshaft oil seal to subsequently slide out the driveshaft itself. Just follow the video to the end!

Updated on 6 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Driveshaft on an Alfa Romeo 147?
How to Replace the Driveshaft on an Alfa Romeo 147?
Alfa Romeo 147 (2000-2010 / MK 1) To replace the driveshaft on an Alfa Romeo 147, lift the car so that the wheel corresponding to the driveshaft to be replaced can be removed from the…
How to Replace the Driveshaft Oil Seal on an Alfa Romeo 147?
How to Replace the Driveshaft Oil Seal on an Alfa Romeo 147?
Alfa Romeo 147 (2000-2010 / MK 1) To replace the driveshaft oil seal on an Alfa Romeo 147, loosen the bolts securing the corresponding wheel so it can be removed. Then, loosen the scr…
How to Remove the Front Bumper from an Alfa Romeo 147
How to Remove the Front Bumper from an Alfa Romeo 147
Alfa Romeo 147 (2000-2010 / MK 1) Before starting, open the bonnet of your Alfa Romeo 147. Begin by unscrewing and removing all screws and bolts that secure the front bumper to the ch…

Other guides you may be interested in

How to Reset the Tyre Pressure Light on the Opel Grandland X

While driving, if you notice the tyre pressure warning light coming on, first check the actual inflation pressure of the tyres and, if necessary, restore the pressures recommended by the manufacturer. After restoring the correct pressures, you need to reset the warning light that has illuminated on the instrument cluster. To do this, locate the reset button on the lower central console. Press this button and hold it down for at least 3 seconds, after which the low pressure indication will turn off.

Watch the video!


by ScegliAuto

More videos