Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A4
    4. : Bearing

Audi A4 - Bearing

Bearing Audi A4 (2000-2004 / b 6)

Audi A4 (2000-2004 / B6)
How to Replace the Front Wheel Bearing
After safely lifting the car, remove the wheel. Next, take off the brake caliper and the brake rotor. Unscrew the central hub bolt. At this point, you need to …Read all…
Posted on 5 March 2026 by ScegliAuto
Audi A4 (2000-2004 / B6)
Replacing Stabilizer Bar Bushings
Lift the vehicle on a hydraulic lift and remove the front wheels (pay attention to any anti-theft bolt); then disconnect the links from the suspension control …Read all…
Posted on 22 February 2026 by ScegliAuto
Accelerator (1) Cigarette lighter (1) Airbag (8) Alternator (7) Speaker (3) Shocks (10) Antenna (1) Air conditioning (11) Car stereo (20) Battery (27) Air vents (1) Bushings (1) Control arm (10) Transmission (5) Spark plugs (10) Glow plugs (4) Convertible top (6) Body (8) Glove compartment (16) Control unit (9) Key (104) Trunk lock (2) Timing belt (48) V-belt (7) Air conditioner (1) A/C controls (6) Onboard computer (14) Checks and maintenance (75) Throttle body (2) Dashboard (7) Shifter boot (3) CV boot (1) Bearing (2) MAF sensor (1) Brake rotors (6) Headlight (33) Tail light (21) Fog lights (5) Diesel particulate filter (2) Air filter (19) Cabin air filter (24) Fuel filter (3) Diesel fuel filter (5) Oil filter (4) Parking brake (4) Clutch (1) Grille (7) Fuel injectors (2) Window switch (3) Accessory kit (7) Xenon headlight kit (1) Light bulb (8) Headlight bulb (30) Tail light bulb (14) Interior dome light bulb (14) Antifreeze coolant (1) License plate light (5) (7) Handle (12) Exhaust muffler (1) Engine (8) Power window motor (7) Starter motor (11) Transmission fluid (6) Engine oil (8) Power steering fluid (1) Clock (23) Door trim panel (45) Windshield (1) Front bumper (18) Rear bumper (11) Brake pads (9) Hydraulic pistons (2) Tires (2) Shift knob (13) Pump (4) Fuel pump (22) Car door (6) Push button (5) Power window switch (9) Instrument cluster (10) Radiator (6) Heater core (7) Wheel (3) Fuse box (88) Seat (28) Axle shaft (4) Crankshaft position sensor (5) Engine coolant temperature sensor (3) Parking sensors (1) Door lock (10) Brake system (2) Suspension system (2) Side mirror (19) Rearview mirror (6) AdBlue warning light (13) Warning light – error code (39) Tire pressure warning light (41) Service warning light (118) Manufacturer emblem (1) Engine mount (2) Fuel cap (8) Windshield wipers (12) Thermostat (14) Tie rods (1) Center console tunnel (3) Turbocharger (3) Valve (3) EGR valve (3) Blower motor (2) Side window (2) Steering wheel (5)

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos