Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Rear Brake Pads on the Audi A3 SportBack

Model: Audi A3 Sportback MK 2 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Checks and maintenance

See other generations:
Video tutorial

This article explains how to replace the rear brake pads on the Audi A3 8P SportBack. To start the replacement, first remove the cap from the brake fluid reservoir, then lift the car or the rear end. Once the car is lifted, use a 17mm socket to loosen the wheel bolts; after they are removed, take off the wheel.

It is advisable to clean the brake caliper mounting points using WD40 and a wire brush.

After cleaning the mounting points, use a 13mm spanner to unscrew the brake caliper bracket, then use a crowbar to separate the brake pads and remove them. Clean the caliper bracket with appropriate products, then apply brake cleaner spray and wait a few minutes.

At this point, install the new brake pads by securing them to the mounting points. After installing the new brake pads, reattach the wheels and secure them by reinserting and tightening the bolts.

The procedure will then be complete, and you can lower the car.


Updated on 26 October 2026 by ScegliAuto


Related tutorials

Audi A3 Sportback (2012-2019 / MK 3) This guide provides instructions for removing and replacing the air vents or diffusers of the air conditioning system on an Audi A3 Sportback. First,…
Audi A3 Sportback (2012-2019 / MK 3) In this video tutorial, we will see how to disassemble and replace the battery of the key remote on an Audi A3 Sportback. First, take the remote in h…
Audi A3 Sportback (2012-2019 / MK 3) In this guide, find out where to locate the fuse boxes and the diagram for the Audi A3 Sportback by following these simple steps. First, locate the i…

Other guides you may be interested in

How to open the bonnet on a Volkswagen Golf?

In this tutorial, you will see how to open the bonnet on a Volkswagen Golf MK4. This is a very simple operation that follows the standard procedure. First, open the driver's door, then locate the lever in the lower left area and pull it. Next, move to the front of the vehicle, lift the bonnet slightly, and find the second lever located just above the Volkswagen logo. At this point, simply pull it towards you, fully open the bonnet, and secure it with the prop rod. To close it, gently push it down.

Watch the video!


by ScegliAuto

More videos