Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A6
    4. : Hydraulic tappet and camshaft

Audi A6 - Video tutorial

Model: Audi A6 MK 2, C5 - Years 1997-2004
Part: Engine
Operation: Hydraulic tappet and camshaft

In the event that an audi engine, characterized by a hydraulic tappet system, is being regenerated, it will be necessary to replace the pistons of the system, the plates and the control rods. Before installing the camshaft, abundantly lubricate the sliding seats, insert the new bushings and then the camshaft itself, repeating the lubrication before applying the fixing brackets and aligning the timing references. Repeat the same steps for the second cylinder bank, insert the oil seals and proceed with the installation on the cylinder block, completing the assembly of the timing belt.


Posted on 2 August 2023 by ScegliAuto



Elimination of engine oil leak from tappet cover
Audi A6 (1997-2004 / MK 2, C5) It is advisable to carry out this repair only if you have good knowledge of mechanics as the parts involved in the disassembly are particularly compl
Replacing the tappet cover gasket
Audi A6 (1997-2004 / MK 2, C5) Before applying the new gasket, it is absolutely essential to carefully clean the gasket seat both on the head side and under the cover itself in ord
Head gasket replacement
Audi A6 (2004-2012 / C6, MK 3) The replacement of the cylinder head gasket requires, in the next phase of assembly of the engine, a whole series of precautions that it is absolutel

Other guides that may interest you

    Frequently Asked Questions

    • A6 2018-2026 - How much does it cost to replace the Audi A6 engine? Read Answer
    • A6 2004-2012 - How many fiscal horsepower does the Audi Rs6 have? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos