Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the swing arm on the Audi A4?

Model: Audi A4 B8 - Years 2007-2016
Part: Control arm

To be able to replace the swing arm of the Audi A4 you have to go and lift the car, so that the corresponding wheel is not in contact with the ground. At this point it will be necessary to loosen the bolts that secure the corresponding wheel, which will have to be removed to give access to the components on the inside. Here, it will be necessary to unscrew the bolts that secure the arm in the part of the hub and in the part of the front axle. When both bolts have been loosened, it will be possible to remove the old arm from its housing, so that it can be replaced with a new spare part.

Posted on 21 October 2022 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the front windshield wipers of the Audi A4
Replacement of the front windshield wipers of the Audi A4
Audi A4 (2000-2004 / B6) Today we will see the instructions that will allow us to disassemble and replace the front wipers of the Audi A4, in simple and quick steps. First of…
How to Remove the Front Control Arm of an Audi A4
How to Remove the Front Control Arm of an Audi A4
Audi A4 (2000-2004 / B6) How to Remove the Front Control Arm of an Audi A4. First, place the car on a column lift and loosen the wheel bolts with a socket wrench. Then, lift …
How to replace the rear wiper blade on an Audi A4
How to replace the rear wiper blade on an Audi A4
Audi A4 (2007-2016 / B8) Before we can begin, we will have to get out of our Audi A4 and head towards the tailgate. So let's start by raising the entire arm of the wiper, thu…

How to Remove the Spark Plugs from a Volkswagen Up

How to remove and replace the spark plugs on a Volkswagen Up? Follow these steps for proper removal. Pull the lever to open the engine compartment and lift the front bonnet, securing it in place. Remove the plastic soundproofing panel on the cylinder head, then disconnect the power connectors using a screwdriver after unscrewing them with a socket wrench. Pull off the coils by hand and unscrew the spark plugs with the socket wrench, finally pulling them out of the cylinder head. Take the new spark plugs and guide them into the engine head using the extension of the socket wrench. Finally, tighten the spark plugs securely and reconnect the respective power connectors. To finish: reassemble the soundproofing panel and close the engine bonnet. - Socket wrench with sockets - Flat or screwdriver bits - Battery-powered screwdriver - Protective gloves.

Watch the video!


by ScegliAuto

More videos