Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Fuel Pump on an Audi Q5

Model: Audi Q5 MK 1, 8R - Years 2008-2017
Part: Fuel pump

This guide will show you the procedure to remove and replace the fuel pump on an Audi Q5. First, open the trunk and start by removing the right side seat cushion to access the fuel pump cover. Then, remove the cover and disconnect the fuel line and the electrical connector for the fuel level sensor, as shown in the video. At this point, remove the pump or float from the tank, replacing it with the new original one. Apply the reverse procedure for reassembly!

Updated on 7 September 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing the Fuel Filler Door on Audi Q5
Removing the Fuel Filler Door on Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) In this video tutorial, you will see instructions on how to remove the fuel filler door on a first-generation Audi Q5. First, open the filler door an…
How to know the fuse diagram of an Audi Q5
How to know the fuse diagram of an Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) In this you can learn about the fuse diagram of an Audi Q5 car and therefore know its arrangements. The first fuse panels that are shown to us are lo…
How to Remove the AdBlue Warning Light in the Audi Q5?
How to Remove the AdBlue Warning Light in the Audi Q5?
Audi Q5 (2017-2025 / MK 2, 80A) If the AdBlue warning light has turned on in your Audi Q5, it means that the emissions fluid has reached a too low level and therefore needs to be re…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos