Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the rear window of the BMW Z3.

Model: BMW Z3 MK 1 - Years 1995-2002
Part: Rear window

Below we will see the main instructions that will allow us to disassemble and replace the rear window of the BMW Z3. First, let's move to the back of the vehicle and start removing the entire seal of the rear window that we find on the sides, using thin and sharp tools; in this case, we are dealing with the roadster version, and the disassembly is done without removing the soft top, as shown in the video. At this point, we install the new rear window, properly applying the new sealant, following the video tutorial until the end!

Posted on 28 December 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Rear Window of the Hood on a BMW Z3
How to Remove the Rear Window of the Hood on a BMW Z3
BMW Z3 (1995-2002 / MK 1) In this tutorial, you will learn how to remove and replace the plastic rear window of the hood on a BMW Z3 by following these simple steps. First, re…
Replacing the gear knob on a BMW Z3
Replacing the gear knob on a BMW Z3
BMW Z3 (1995-2002 / MK 1) In this video tutorial, you will see how to remove the gear knob along with its gaiter on a BMW Z3. First, get inside the car and unclip the gear gai…
How to Replace the Left Handle Frame on a BMW Z3
How to Replace the Left Handle Frame on a BMW Z3
BMW Z3 (1995-2002 / MK 1) Before you can start, open the left door of your BMW Z3. Begin by prising off the cap on the side of the door using a flathead screwdriver. Next, unc…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos