Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Rear Bumper Cover on BMW 5 Series

Model: BMW Serie 5 E60, E61 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010
Part: Rear bumper

See other generations:
Video tutorial

In this video tutorial, you will see the main steps to remove the rear bumper cover of a BMW 5 Series E60. First, open the trunk and remove the various screws. Disconnect the electrical connector to remove the two tail lights.

Next, unscrew the bolts located at the back of the tail light and the screws found behind the fender on both sides. Detach the bumper cover and the bumper as shown in the video.

At this point, you can reassemble everything: just follow the instructions illustrated in the video!


Updated on 30 March 2026 by ScegliAuto


Related tutorials

How to Remove the Rear Door Panel of the BMW 5 Series
How to Remove the Rear Door Panel of the BMW 5 Series
BMW Serie 5 (2010-2017 / F11, F10) Today, let's go through the procedure for removing the rear door panel of the BMW 5 Series. First, open the rear door of the vehicle and start by rem…
Replace the Front Grilles on BMW 5 Series
Replace the Front Grilles on BMW 5 Series
BMW Serie 5 (1995-2003 / E39) Replace the center grille on the BMW 5 Series; let's look at the disassembly. Remove the two plastic grille frames on either side of the bumper. Use …
Removing Front Headrest on BMW 5 Series E60
Removing Front Headrest on BMW 5 Series E60
BMW Serie 5 (2003-2010 / E60, E61) In today's video, you will learn how to remove the front headrest on a BMW 5 Series E60 by following these simple steps. First, open the front door a…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos