Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the rear light of the BMW 5 Series

Model: BMW Serie 5 F11, F10 - Years 2010-2017
Part: Tail light

The following video tutorial will show you the steps to replace the rear headlight of the BMW 5 Series model F10 produced from 2010 to 2017. The first step is to open the trunk of the car. The second step is to remove the trunk cover related to the right rear headlight. The third step is to unscrew the screws that hold the headlight and disconnect the connector. The fourth step is to remove the headlight. The fifth step is to insert the new headlight into the housing, connect the connector, and screw in the screws. The sixth step is to connect the headlight wires to the electrical components inside the rear panel of the tailgate. Once the cover is closed, proceed to replace the left rear headlight by following the same steps.

Posted on 3 June 2025 by ScegliAuto

Video tutorial

Related tutorials

How to replace the external rearview mirror of the BMW 5 Series
How to replace the external rearview mirror of the BMW 5 Series
BMW Serie 5 (2017-2024 / G30) Today's instructions will show us the steps on how to disassemble and replace the external rearview mirror of the BMW 5 Series. First, we open the fr…
How to replace the battery of the BMW 5 Series E60 key
How to replace the battery of the BMW 5 Series E60 key
BMW Serie 5 (2003-2010 / E61, E60) If you need to replace the battery in the key of your BMW 5 Series e60, simply read the following procedure carefully and follow all the steps. First…
Where to Find the Fuse Box of the BMW 5 Series E60
Where to Find the Fuse Box of the BMW 5 Series E60
BMW Serie 5 (2003-2010 / E61, E60) Unlike many other car models, in the BMW 5 Series E60 (2003-2010), the fuse box is not located in the engine compartment or inside the cabin, but in …

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos