Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How to replace the oil filter and O-ring in a BMW 3 Series

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E92, E91, E90 - Years 2005-2013
Part: Oil filter
Operation: How to replace the oil filter and O-ring in a BMW 3 Series

This short video illustrates the procedure for replacing the oil filter and O-ring (or gasket) in a BMW 3 Series. The first thing to do is to unscrew the cap of the oil container, using the wrench if necessary. suitable, extract the faulty gasket and carefully clean the cap. At this point, it will be necessary to extract the old oil filter and, also in this case, thoroughly clean everything. Once this is done, you can insert the new gasket in the cap and the new oil filter in the special container. In a few minutes you will have done a DIY job like a mechanic!


Posted on 29 December 2023 by ScegliAuto

    Frequently Asked Questions

    • Serie 3 2005-2013 - Where is the oil filter on BMW 3 Series? Read Answer
    • Serie 3 1998-2006 - Where is the BMW E46 oil filter located? Read Answer
    • Serie 3 1998-2006 - Where is the BMW E46 oil filter located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos