Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Differential Oil on BMW F30

Model: BMW Serie 3 F31, F30 - Years: 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019
Part: Differential

See other generations:
Video tutorial

This guide shows how to replace the differential oil on BMW F30 models. First, lift the vehicle and remove the protective cover from the differential using an E12 wrench.

After opening the 14mm plug that allows fluid drainage, use a BMW differential fluid extractor to pump out the old lubricant. With a plastic syringe and a plastic tube as an extension, insert the new lubricant into the differential.

Use only the fluid recommended by the manufacturer. The fluid level should slightly exceed the fill hole.

Drain the oil into a disposal container and reinstall the reservoir plug. Tighten it to a torque of 44 lb-ft and clean any oil residue from the exterior of the differential.

Reattach the differential protective cover and lower the vehicle. At this point, the operation is complete.


Updated on 25 April 2026 by ScegliAuto


Related tutorials

Differential Oil Change
Differential Oil Change
BMW Serie 3 (1998-2006 / E46) Periodic oil changes are essential to maintain mechanical efficiency. Lift the vehicle securely. Drain the differential oil by removing the upper and…
Guide to Removing the Rear Differential on the BMW 3 Series
Guide to Removing the Rear Differential on the BMW 3 Series
BMW Serie 3 (2012-2019 / F31, F30) Today's guide will show you the steps to remove and replace the rear differential on the BMW 3 Series. First, raise the vehicle and start disconnecti…
How to Reset the Oil Light on BMW 3 Series F30
How to Reset the Oil Light on BMW 3 Series F30
BMW Serie 3 (2012-2019 / F31, F30) If the orange oil light on the instrument cluster of your BMW 3 Series F30 (2012-2019) stays on even after you have changed the oil, you need to perf…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos