Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Shark Fin Antenna from the BMW X1

Model: BMW X1 F48 - Years 2015-2022
Part: Antenna

This guide shows how to remove the shark fin antenna from the BMW X1. No special tools are required; just use a plastic trim tool and some tape to protect the body. Using a Torx screwdriver, remove the retaining screw of the receiver element. Carefully pull it upward to avoid damaging the electrical connections and disconnect the wiring. Install the new receiver element and reassemble everything in place. Before fully closing the antenna cover, check its operation.

Updated on 7 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to change the battery in the emergency call system of a BMW X1
How to change the battery in the emergency call system of a BMW X1
BMW X1 (2015-2022 / F48) In this video, we can see how to change the emergency system battery of the BMW X1. The battery is installed directly in the rescue module, which is …
Where to Find the Fuse Box of the BMW X1
BMW X1 (2009-2015 / E84) To locate the fuse box of your first-generation BMW X1 (2009-2015), carefully read this mini guide and follow the steps outlined. First, turn off the…
Where to Find the Fuse Box of the BMW X1 E84
Where to Find the Fuse Box of the BMW X1 E84
BMW X1 (2009-2015 / E84) In this new mini guide for your BMW X1 E84 (model years 2009-2015), find out where all the various fuses of the vehicle are located. Once found, you …

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos