Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Windshield Washer Pump on a BMW 3 Series

Model: BMW Serie 3 E46 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Pump

See other generations:
Video tutorial

In this guide, you will learn the procedure to remove and replace the windshield washer pump on a BMW 3 Series in simple steps. First, open the hood and start unscrewing the screws located on the top of the washer fluid reservoir to detach it. Next, disconnect the electrical connector from the pump to remove it from the reservoir, as shown in the video.

Now, install the new windshield washer pump; connect the electrical cable and reattach the reservoir, securing it properly with the screws!


Updated on 9 May 2026 by ScegliAuto


Related tutorials

Replacement of the windshield washer pump of the BMW 3 Series 328I
Replacement of the windshield washer pump of the BMW 3 Series 328I
BMW Serie 3 (1998-2006 / E46) The following steps will allow us to disassemble and replace the windshield washer pump of the BMW 3 Series 328I. First, we open the hood of the car …
How to Replace the Windshield Washer Pump on a BMW 3 Series
BMW Serie 3 (2012-2019 / F31, F30) Below are the instructions needed to disassemble and replace the windshield washer pump on the BMW 3 Series. First, raise the vehicle and begin by re…
Replacement of the windshield washer pump of the BMW 3 Series
Replacement of the windshield washer pump of the BMW 3 Series
BMW Serie 3 (2005-2013 / E92, E90, E91) These short and simple steps will show us how to dismantle and replace the windshield washer pump of the BMW 3 Series. First, lift the vehicle and st…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos