Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the windshield washer pump of the BMW 3 Series

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Pump

These short and simple steps will show us how to dismantle and replace the windshield washer pump of the BMW 3 Series. First, lift the vehicle and start by disassembling and removing the front right wheel; then remove the fender liner, thus accessing the windshield washer pump, as shown in the video. At this point, disconnect the electrical connector and the fluid tubing, letting it drain into a container; replace the windshield washer pump with the new original one, securely attaching it to the reservoir. Reassemble everything and top up with the new windshield washer fluid!

Posted on 23 October 2025 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the windshield washer pump of the BMW 3 Series 328I
Replacement of the windshield washer pump of the BMW 3 Series 328I
BMW Serie 3 (1998-2006 / E46) The following steps will allow us to disassemble and replace the windshield washer pump of the BMW 3 Series 328I. First, we open the hood of the car …
Windshield Washer Pump Repair Near Me
Windshield Washer Pump Repair Near Me
BMW Serie 3 (2005-2013 / E91, E90, E92) If you need to repair or replace the windshield washer pump on this vehicle, refer to the instructions below and the video. The first step is to remo…
How to find out the fuse diagram of a BMW Series 3
How to find out the fuse diagram of a BMW Series 3
BMW Serie 3 (1998-2006 / E46) The selected video shows the diagrams related to the fuse boxes present in a BMW Series 3 car. The fuse panels are located inside the vehicle's cabin…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos