Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the windshield washer pump of the BMW 3 Series 328I

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Pump

The following steps will allow us to disassemble and replace the windshield washer pump of the BMW 3 Series 328I. First, we open the hood of the car and start by removing the windshield washer fluid reservoir, in order to access the windshield washer pump located at the bottom attached to it; then we disconnect the pump tubing and the electrical connector, in order to remove it, as shown in the video. At this point, we install the new windshield washer pump, making the connection and verifying its correct operation before reassembling the windshield washer fluid reservoir.

Posted on 21 April 2025 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the windshield washer pump of the BMW 3 Series
Replacement of the windshield washer pump of the BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) These short and simple steps will show us how to dismantle and replace the windshield washer pump of the BMW 3 Series. First, lift the vehicle and st…
How to Replace the Windshield Washer Pump on a BMW 3 Series
BMW Serie 3 (2012-2019 / F30, F31) Below are the instructions needed to disassemble and replace the windshield washer pump on the BMW 3 Series. First, raise the vehicle and begin by re…
How to Replace the Windshield Washer Pump on a BMW 3 Series
How to Replace the Windshield Washer Pump on a BMW 3 Series
BMW Serie 3 (1998-2006 / E46) In this guide, you will learn the procedure to remove and replace the windshield washer pump on a BMW 3 Series in simple steps. First, open the hood …

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos