Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Parking Sensor on the BMW X5

Model: BMW X5 E53 - Years 1999-2006
Part: Parking sensors

Today, you will see in this video tutorial how to remove and replace the parking sensor on the BMW X5 by following these simple and quick steps. First, get something thin and pointed, and start disassembling and removing the small parking sensor. Apply some penetrating oil and be careful not to damage the bumper's bodywork, as shown in the video. At this point, disconnect the electrical connector of the sensor located at the back, and replace it with the new one (of the correct type); apply the reverse procedure for reassembly!

Updated on 11 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Steering Angle Sensor on the BMW X5 E53
How to Replace the Steering Angle Sensor on the BMW X5 E53
BMW X5 (1999-2006 / E53) In this video, we will go through the main steps to remove and replace the steering angle sensor on the first generation BMW X5 E53. First, get insid…
How to Reset the Electronic Parking Brake on the BMW X5
How to Reset the Electronic Parking Brake on the BMW X5
BMW X5 (2007-2013 / E70) To reset the electronic parking brake on the BMW X5, open the rear trunk. Next, lift the carpet at the base of the trunk: this will allow you to acce…
How to Replace the Steering Angle Sensor on the BMW X5?
How to Replace the Steering Angle Sensor on the BMW X5?
BMW X5 (1999-2006 / E53) To replace the steering angle sensor on the BMW X5, you must completely disassemble the steering column. First, remove all the trim pieces around the…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos