Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Synchronize and Reset the BMW 3 Series Convertible Top

Model: BMW Serie 3 E36 - Years 1990-2001
Part: Warning light – error code

This guide provides instructions to reset and synchronize the convertible top of the BMW 3 Series, following these simple steps. First, open the trunk lid and start removing the carpet lining found in the trunk; then disconnect the electrical connector from the convertible top motor to perform the reset, as shown in the video. At this point, check and synchronize the vehicle's convertible top again, ensuring it closes properly, following the video tutorial to the end!

Updated on 22 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Manually Open and Close the BMW 3 Series Convertible Top
How to Manually Open and Close the BMW 3 Series Convertible Top
BMW Serie 3 (1990-2001 / E36) This guide provides instructions to manually open and close the convertible top of the BMW 3 Series. First, open the trunk lid and begin to manually …
How to put the seal between the hood and rear window on a BMW 3 Series E36
How to put the seal between the hood and rear window on a BMW 3 Series E36
BMW Serie 3 (1990-2001 / E36) In this case we have a BMW 3 Series E36 convertible version, where the problem of the hood coming off from the rear window has occurred. We advise yo…
How to Reprogram the Key of the BMW E46
How to Reprogram the Key of the BMW E46
BMW Serie 3 (1998-2006 / E46) This video shows the procedure to reprogram the key for your BMW 3 Series E46. The procedure takes less than 1 minute to complete. To reprogram the k…

    Frequently Asked Questions

    • Serie 3 2012-2019 - What does the BMW 3 Series F30 blue battery light mean? Read answer
    • Serie 3 2005-2013 - What does the check engine light mean on the BMW 3 Series E90? Read answer
    • Serie 3 1998-2006 - What does the EML light indicate in the BMW 3 Series? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos